Личный Фотокабинет »

Support » Guidelines » Technical Requirements for Films

Requirements for the films to be processed

1. We accept for our operations negatives and positive films.

2. We accept colour and black and white, as well as monochrome films.

3. The following types of films are accepted: 135 films, 120/220 films, 9x12, 13x18 and 18x24 sheet films.

4. A reel of undeveloped film or a box containing undeveloped film must be marked (film developing process). Photographic films without such markings are not accepted for processing.

Processed Films

1. We take accept for processing reversal (negative) and positive films.

2. We accept colour, black and white, as well as monochrome films.

3. The following types of films are accepted: 135 films, 120/220 films, 9x12, 13x18 and 18x24 sheet films.

4. We accept cut films if the length of its each part is not less than 15 cm (about three standard frames in size of 36x24 mm for 135 film).

5. A film must not be twisted into a tight roll.

6. A film must not be old (must not contain a self-detaching emulsion layer, be dirty, etc.).

7. A film must be clean (must not contain dirt layers or particles of dirt, encrusted dust, etc.).

8. A film must be dry and can not contain traces of water left over from a drying process.

9. A film must have an intact emulsion layer (must not be defective, scratched, etc.).

10. A film must have intact perforations.

11. A film must not be deformed (have crumpled areas or creases).

12. A film must have a clearly visible image against the light.